Here are the two blocks side by side. The left is the original. The stem seemed a little thick and clunky so I modified it to create the thinner stem on the right. This new stem DOES take longer to make but I like the effect.
Please note: this is an add on to the original tutorial. You will need to reference that tutorial for most of the cutting and sewing directions. This stem modification replaces the two 2" squares in print C as noted in the cutting directions of the original tutorial.
Cutting Directions: omit two 2" squares in print C and cut as follows:
cut one - 1” x 2” in print A
cut one - 1” x 2” in print B
cut one - 1” x 3.5” in print C
cut two - 1” x 2.5”
This is what your pieces will look like when you've cut them!
Take the two white pieces and mark a point one inch away from the end using a removable marker. Make sure to mark the opposite side of each piece.
You should end up with two pieces that look like this.
Using a removable marker and ruler, draw a straight line between the dot and the closest diagonally opposite corner. You are essentially marking a half-square triangle on the corner of the piece.
When you have marked the line on both pieces they should look like this. Notice they are opposite!
Place the white pieces and green pieces at right angles with the marked corner of the white overlapping the green.
Sew and trim the corner to a quarter inch.
Sew the piece together in three sections: the right side leaves, the stem and inner leaves and the left side leaves. You will have three pieces as shown.
I know there are a few people who have been looking out for this stem update. Thank you for your patience. I hope you enjoy it! Feel free to ask any questions in the comments below so the answers can be helpful to others with the same question. And if you spot any errors let me know so I can fix them right away! Enjoy!